18
ENGLISH
4
Insert the lter into the empty water tank. Press it down until it cannot
move any further.
5
Fill the water tank with fresh water and reinsert it into the machine.
6
Dispense all the water of the tank by using the hot water function (see
“Hot Water Dispensing” chapter).
7
Fill the water tank again.
Yellow
8
Press the “ ” button and scroll the pages by pressing the “ ” but-
ton until the following screen is displayed.
9
Press the “ ” button to select “ON” and press the “ ” button to
con rm.
Yellow
10
To exit, press the “ ” button. The machine shows this display and is
ready to brew.
In this way the machine has been programmed to inform the user of
the need to replace the “INTENZA+” water lter.
Green
3
Set the lter according to the measurements performed (see previous
chapter) and indicated on the base of the lter:
A = soft water – equals 1 or 2 on the test strip
B = hard water (standard) – equals 3 on the test strip
C = very hard water – equals 4 on the test strip
To Next Page
Loading...
