52
ENGLISH
Ready Signals (Green Colour)
The machine is programming the amount of co ee to be brewed.
Co ee brewing using pre-ground co ee in progress.
Warning Signals (Yellow Colour)
The machine is in warm-up phase to brew beverages or dispense hot water.
The machine is in warm-up phase during beverages programming.
The machine is performing the rinse phase. Wait until the machine has com-
pleted the cycle.
The machine needs the "INTENZA+" water lter to be replaced.
The brew group is being reset due to machine reset.
Re ll the co ee bean hopper with co ee beans and restart the cycle.
Prime the circuit.
The machine needs to be descaled. Press the “ ” button to enter the descal-
ing menu. Follow the steps described in the descaling chapter of this manual.
If you want to descale later, press the
“ ” button to continue using the ma-
chine.
Please note that not descaling your machine will ultimately make it stop
working properly. In this case repair is NOT covered under your warranty.
To Next Page
Loading...
