1234
1234
>>>> 5
5
> >>6
6
7
7
1.
2.
4.
3.
5
12
12
>>3
3
>
12
12
>>3
3
>
1.
2.
1234
1234
>> >>5
5
>
1234 56
1234 56
>>>>>>
123456
123456
>>> >>>
1234
1234
>>>> >5
5
12
12
>>3
3
>
12
12
>>
1
3
4
2
TSM S
UCCESS
M
ANUAL
® -
©0
901
- by SEV/ ASE
Fill coffee beans
Preparation
Fill fresh water
Plug power cord into
power socket
See plate on
the machine
STARTING
Switch on power
Place receptacle
under nozzle
Draw off hot water until
it flows evenly
Ventilate
flashing: machine is warming up
steady: machine ready
If the device has not been used for
a long period of time, ventilate (prime the unit)
before starting
Coffee bean container
Adjusting lever for degree of grinding
Adjusting lever for quantity of coffee
Fresh water tank
Main power switch
Turning knob steam /hot water
Operating panel
Optional handles
Hot water/steam nozzle
Pre-ground coffee
Espresso
Coffee
Steam
Descale
PREPARATION
only when required
ADJUST
1) Place cup under nozzle
2) Press and hold down desired
button (espresso or coffee)
3) Release button when
correct amount is reached
4) Quantity remains stored in memory
Amount of coffee
fine coarse
fast: set to a
finer grind
slow: set to a
coarser grind
Coffee flows too …
Degree of grinding
only adjust when
grinder is running
COFFEE BEANS
PRE-GROUND COFFEE
CAPPUCCINO
STEAM
HOT WATER
Place cup(s) under nozzle
Different cup sizes are possible
Adjust coffee dispensing unit
Adjust height of unit to fit cup size
Select quantity of beans
to be ground per serving
Press 1 x for 1 cup
Press 2 x for 2 cups
Remove cup(s)
To improve crema
- Use another coffee roast
(insure that it is the appropriate sort
of coffee for fully automatic
espresso machines)
- Use fresh roasted coffee beans
- Change degree of grinding
Espresso or
Coffee
weak
coffee
Place cup under nozzle
Different cup sizes are possible
Adjust coffee distributing unit
Adjust height of unit to fit cup size
Select pre-ground coffee
-
Max. 1 level measure
-
NEVER use instant coffee
!
Fill up with powder
Press 1 x Remove cup
Add frothed milk to your
coffee
Fill 1/3 cup with cold milk
Select steam
Button flashes: warming up
Button steady:
ready
Start steam preparation
- Purge leftover water
- Close turning knob
Place cup under nozzle
- Immerse nozzle 3-4 cm/1-1.5”
deep
- Open turning knob
Froth up milk
Move cup while frothing …
End preparation and
remove cup
Clean nozzle with damp
cloth
so that the froth does not
dry on nozzle
Select steam
Button flashes: warming up
Button steady:
ready
Start steam preparation
Purge leftover water
Heat up drink by rotating
cup while filling
End preparation
and remove cup
Clean nozzle with damp
cloth
so that the froth does not
dry on nozzle
After using CAPPUCCINO/ STEAM
Press «Steam» button and draw off 1 cup of hot water
so that the water cools down to normal coffee temperature.
See ventilate 1 and 3 (STARTING)
Adjust nozzle if necessary
Place cup under nozzle Draw off hot water
End preparation
and remove cup
Espresso or
Coffee
PROGRAMMING
Start here
Switch off
and
To start programming mode, press both buttons,
hold them down, and switch on machine again
Hardness 1
Hardness 2
Hardness 3*
Hardness 4
...until appropriate setting...
Measure water hardness
Insert test strip and
read after 1 min.
1 sec.
Press button...
Machine rinse function
As soon as the machine
has been switched on,
the remaining water is
rinsed out. Therefore,
the very first cup of
coffee is made with
fresh water
Press button
activated
not activated
Prebrewing function
The coffee is first
moistened and then
brewed after a short pause!
activated
not activated
Press button
Pregrinding function
During preparation,
the next portion of coffee
will already be ground
(ideal if several coffees
need to be prepared)
activated
not activated
Press button
End here
Switch off É
and switch on again to
activate the programmed functions
Coffee dispensing unit (adjustable)
Coffee dregs drawer
(access: open service door)
Funnel for pre-ground coffee
Refill with beans
Empty coffee dregs drawer
strong
coffee
*Factory preset
Place cup below
Immerse nozzle 3-4 cm/1-1.5”
deep in drink
Start hot water preparation
Observe display
The machine comes set to a
middle value. Recommended
setting is 8 (+4 / -2)
Service door/brewing unit
Insert drip tray /drip grill
Display: drip tray full
Malfunction
Refill with water
Ventilate (prime) machine
The switch is placed on
the machine back.
To Previous Page
Loading...
