SAEHAN DHD-1 - Page 21

To Next Page

To Previous Page

Setting Mode

1. Press PWR button once to turn on the device (in Testing Mode).

2. Press and hold the SET button for Setting Mode. After two beeps, “set

DATE” appears on the display and the value for the Month ﬂ ashes.

3. Press the READ button repeatedly to advance to the desired Month number (mm).

4. Press the HAND button once and the value for Day flashes. Press the

READ button repeatedly to advance to the desired Day number (dd).

5. Press the SET button once and the value for the ﬁ rst digit of the four-digit

Yea r ﬂ ashes. Press the READ button repeatedly to advance to the desired

ﬁ rst digit of Year (yyyy).

6. Press the HAND button once and the value for the second digit of the four-

digit Year flashes. Press the READ button repeatedly to advance to the

desired second digit of Year (yyyy).

7. Press the HAND button once and the value for the third digit of the four-

digit Year flashes. Press the READ button repeatedly to advance to the

desired third digit of Year (yyyy).

8. Press the HAND button once and the value for the fourth digit of the four-

digit Year flashes. Press the READ button repeatedly to advance to the

desired fourth digit of Year (yyyy).

9. Press the SET button once. After one beep, “set TIME” appears on

the display and the value for the Hour flashes. Press the READ button

repeatedly to advance to the desired Hour number (hh).

10. Press the HAND button once and the value for Minutes ﬂ ashes. Press the

READ button repeatedly to advance to the desired Minute number (mm).

11. Press the SAVE button to save the DATE and TIME. “SAVE” appears

brieﬂ y on the display, and the DHD-1 returns to Testing Mode.

12. Press and hold the

PWR button to power off the DHD-1.

Note: The DATE and TIME settings as well as saved test results are retained after

the DHD-1 is powered off. However, if the DHD-1 battery is completely

discharged, saved test results are still retained when re-connected to a

PC for power, but the DATE and TIME will be set to their initial values

(06.15, 2011, and 12:00). Enter the DATE and TIME settings then keep

the DHD-1 connected to a PC until the battery is fully recharged.

DHD-1 Digital Hand Dynamometer – Operation