User Guide
Front Panel
1. Time Set Button 8. Test Switch
2. Alarm Set Button 9. Vibrating Pad Port
3. Snooze Button 10. Volume Switch
4. Hour Adjust Button 11. USB Port
5. Minutes Adjust Button 12. Audio Tone Switch
6. Alarm Switch 13. Power Cable Port
7. Display Dimmer Switch 14. LED Side Light Switch
Back Panel
Instructions:
Insert the Vibrating Pad jack into the Vibrating Pad Port
(9) and insert the power supply jack into Power Cable
Port (13). Insert the power supply plug into a socket and
switch on.
If keeping the clock by your bed we recommend the
vibrating pad is placed under a pillow.
To set time:
Press and hold the Time button (1), followed by the
Hour button (4) to change the digit, press several times
until you reach the desired hour. Do the same for the
minutes by pressing the Minute button (5) together with
the Time button (1).
To set alarm:
Press and hold the Alarm button (2) followed by the
Hour (4) and Minutes (5) buttons to the desired time.
Set the alarm switch (6) to the on position.
How to turn off the alarm:
When the alarm goes off, press the Snooze button (3) to
snooze the alarm for approx. 9 minutes. You can
continue this process 7 times before the alarm mode
turns off. To switch the alarm off straight away, or stop
snooze mode, press and hold the Snooze button (3) for
3 seconds.
The set alarm will then repeat at the desired time the
next day.
Other functions
Test the Alarm
You can test the alarm mode by pressing the test button
(8) to release. When the button is protruding out the
test mode will activate. Push the button back in to turn
the test off.
Charge your Mobile Phone
Insert your mobile phone’s USB charger into the USB
port (11). Can be used to charge most 5V mobile phones
or other electronic devices.
Adjust the clock display and Alarm Sound
The brightness of the display can be adjusted by pressing
the display dimmer switch (7).
You can choose the desired volume of the alarm sound
by adjusting the volume switch (10) between HI, LO and
OFF. The tone of the alarm sound can also be adjusted
using the Audio Tone switch (12) between HI, MED and
LO.
The clock’s lights can be turned on/off using the LED side
light switch (14).
Power Cut
In the case of a power cut the clock will memorise the
time for up to 72 hours so no need to reset the time and
it ensures the alarm remains correct while you are
sleeping.
To Next Page
Need help?
General