Need help?Do you have a question about the Safire DVR6104V-H and is the answer not in the manual?
Lists network protocols, port mapping, and remote access features.
Details the functions and usage of the infrared remote control.
Provides crucial steps for powering the device on and off.
Guides users through initial setup using the on-screen wizard.
Explains how to add and configure IP cameras for HDVR models.
Details the process of detecting and adding online IP cameras.
Describes how to edit and manage the settings of added IP cameras.
Explains what Live View is and how it functions.
Covers various functions available during live viewing.
Details mouse interactions within the Live View interface.
Describes how to switch between main and auxiliary video outputs.
Allows customization of live view parameters like output and dwell time.
Details how to set up parameters for PTZ cameras.
Covers configuring specific camera positions and movements.
Guides on setting predefined camera positions.
Explains how to activate saved PTZ camera positions.
Details setting up automated camera movement sequences.
Guides on activating predefined patrol paths.
Explains how to record and save PTZ camera movement paths.
Describes how to activate saved PTZ movement patterns.
Sets resolution, bitrate, and stream type for recording.
Allows setting automated recording times and types.
Details how to set up motion detection for triggering recordings.
Covers locking files and setting HDD to read-only to prevent overwrites.
General section on accessing recorded footage.
General procedures for backing up recorded data.
Configuring motion detection parameters and response actions.
Setting up alarms for video signal loss.
Configuring alarms for camera lens tampering.
Setting up responses for various system exceptions like HDD full.
Defining actions taken when an alarm is triggered.
Basic network configuration like IP address and DNS.
Preparing a new HDD for use by the device.
Setting up zones to obscure sensitive areas in video feeds.
Adjusting image settings like brightness, contrast, and sharpness.
Updating the device firmware.
Resetting the device to factory default configurations.
General| Compression Format | H.264 |
|---|---|
| Video Input Channels | 4 |
| Video Output | 1 |
| Network Interface | RJ45 |
| Power Supply | 12V DC |
| Audio Output | 1 |
| Hard Drive Support | 1 SATA |
| Remote Viewing | Yes |
| Mobile Support | Yes |
| Operating System Compatibility | Windows |
| USB Interface | 2 |
| Operating Temperature | -10°C to 55°C |
To Next Page
