Sagem ADR 155C - Page 32

1 - INSTALLATION AND COMMISSIONING
Installation and User Guide - N56717020101
Page A1-24
No reproduction or communication without the written consent of
SAGEM SA
The screen displays the 5 communication interfaces possible, with their characteristics, and
proposes to change each of them by turns. These interfaces are:
- an Ethernet port –ETH
- 4 PPP (Point to Point Protocol) portes – PPP1 to PPP4 - to be chosen from the following
management paths:
either at bytes D1 to D3 of channel DCC1 of an STM1 frame (named DCC1-A, DCC1-B,
DCC1-C or DCC1-D according to the number and position of ADR IC1.x modules in the
equipment), or the MNGT interface
Each interface is defined by its characteristics:
- "Port" : physical port "ETH", "PPP1" to "PPP4"
- "Admin" or interface state: "ON" (interface active) or "OFF" (interface inactive)
- "@ IP" : IP address
- "subnet mask" : subnetwork mask
- "@ IP of dest" : destination IP address (for PPP ports only)
- "Path" : management path chosen for the PPP ports (DCC1x or MNGT)
- "RIP" : management routing self-adaptability to the network structure validated or not (limited
to 16 hops without gateway)
The parameterization is backed up port by port.
) Choice "2" : Configuration of static routes,
The screen displays the already defined management routes with their characteristics:
- "No" : reference of the route
- "destination @ IP" : destination IP address (equipment or subnetwork)
- "subnet mask" : subnetwork mask
- "next hop @ IP" : IP address of the next equipment (connected on line with the given
equipment)