Sagem ADR 155C - Page 41

2 - OPERATION
Installation and User Guide - N56717020101
No reproduction or communication without the written consent of
SAGEM SA
Page A2-5
Configuration parameters per functional blocks Default
value
ADRLAN Card – continue
Interface configuration
- LAN in service / no service
- Maximum route Age
- Path trace J1 transmitted :
"UNNAMED VC3" + CRC7 not configurable and not treated in reception
Service
300 s
"UNNAMED .
VC3" + CRC7
SETS : Synchronous Equipment Timing Source
Quality level of synchronization sources ; "Quality" :
-"PRC" (Primary Reference Clock),
-"SSUT" (Synchronisation Supply Unit Transit),
-"SSUL" (Synchronisation Supply Unit Local),
-"SEC" (Synchronisation Equipment Clock),
-"DNU" (Do Not Use),
-"SSMB" (Synchronisation Status Message Byte) (synchronization quality
carried out in S1 Byte).
T3 : PRC
T1 : SSMB
T2 : SEC
T4 : SEC
Use of synchronization status messages (SSM) ;
"SSM" "ON"
T0 priority Table, according to enabled sources ;
possible values : 1 to 8
"1"
for all sources
2 Mbit/s port number chosen for T2 ; "T2 Tributary port"
(1 port per enabled 2 Mbit/s card)
"1"
Revertive authorization (common to all sources) : return after a WTR time-
delay to the working link when the fault (SF or SD) causing the switch has
disappeared.
"Revertive"
"yes"
Wait Time to Restore (WTR) period : in revertive mode, period following
restoration of nominal operation ; configurable from 0 to 30mn by one-
second step
"WTR" "1 mn"
Source selected for T4 ;
"Active source"
"T0"
SASE mode control (enable or disable) disabled
T3 source selection for SASE mode (T3-1 or T3-2)
T3-1
Quality level for T4
-"PRC" (Primary Reference Clock),
-"SSUT" (Synchronisation Supply Unit Transit),
-"SSUL" (Synchronisation Supply Unit Local),
-"SEC" (Synchronisation Equipment Clock),
"PRC"
Table 2-4 – Configuration parameters (4/6)