2 - OPERATION
Installation and User Guide - N56717020101
Page A2-8
No reproduction or communication without the written consent of
SAGEM SA
Maintenance operation commands
Monitoring commands according to the functional blocks
SPI : SDH Physical Interface
2s laser restart on operator action
9s laser restart on operator action
Line loopback enabled/disabled (transparent type)
Equipment loopback enabled/disabled (transparent type)
MSP : Multiplex Section Protection
Operator command for MSP protection
Clear
Lockout of Protection
Forced Switch to Working
Forced Switch to Protection
Manual Switch to Working
Manual Switch to Protection
LPC : Lower order Path Connection
Operator command for SNC protection of VC12 or VC3 path (per path and in order of priority):
Clear
Lockout of Protection
Forced Switch to Working
Forced Switch to Protection
Manual Switch to Working
Manual Switch to Protection
PPI : PDH Physical Interface
Line loopback enabled/disabled (transparent type)
Equipment loopback enabled/disabled (transparent type)
ADRLAN Card
LAN statistics
VC3 # i statistics
Flow control
Interface status-
SETS : Synchronous Equipment Timing Source
Protection operator command
Clear
Lockout of Protection
Forced Switch
Manual Switch to Protection
Table 2-7- Commands (1/2)
To Next Page
Loading...