Sagem Ultima 600 - User Manual

S Ref.: 21821085-0/A
Issue 02/99 1-1
S
MAINTENANCE MANUAL
AFTER SALES DEPARTMENT
ZI Route de MAMERS
72405 LA FERTE-BERNARD - France
Tel.: 02 43 60 43 60 - Fax: 02 43 60 43 61
Printed in France; total or partial reproduction prohibited without prior written authorization. The information contained in this
document is subject to change without prior notice and cannot be understood under any circumstances as contractually binding.
.
ULTIMA 600

Summary

SECTION 2 UNPACKAGING AND COMMISSIONING

2.1 UNPACKAGING THE UNIT

Instructions for safely unpacking the ULTIMA 600, including opening boxes and checking contents.

2.1.2 SETTING UP THE UNIT

Guidance on proper placement, power connection, and environmental conditions for operating the ULTIMA 600.

2.1.3 INSTALLING PRINTER PAPER AND TUBES

Steps to install printer paper and connect gas sampling, power, and evacuation tubes to the unit.

2.1.6 INITIAL STARTUP PROCEDURE

Steps for initial power connection, unit start-up, and verification of the display sequence.

SECTION 3 DESCRIPTION AND OPERATION

3.1 GENERAL INFORMATION

Overview of the ULTIMA 600 gas analyzer's functions and its compatibility with opacimeter options.

3.2 FRONT PANEL DESCRIPTION

Detailed description of the ULTIMA 600's front panel components, including the graphic display and keypad.

3.3 REAR PANEL DESCRIPTION

Identification and explanation of all connectors and ports located on the rear panel of the ULTIMA 600.

3.4 PNEUMATIC CIRCUIT DESCRIPTION

Schematic diagram and explanation of the ULTIMA 600's pneumatic circuit, detailing its components and flow.

SECTION 4 PREVENTIVE MAINTENANCE

4.1 GAS MODE CUSTOMER SELFTEST

Customer-accessible self-tests in GAS mode, covering tightness, version, Lambda, and HC residue.

4.2 SERVICE MAINTENANCE MODE

Procedures for accessing and utilizing the SERVICE mode for unit configuration and information retrieval.

4.3 OPACITY MODE CUSTOMER SELFTEST

Self-testing procedures for the OPACITY mode, including temperature sensor and software status checks.

SECTION 5 CORRECTIVE MAINTENANCE

5.1 SOFTWARE MAINTENANCE

Maintenance tasks related to software, including adjustments, sensor replacement, and software downloading.

5.2 HARDWARE MAINTENANCE

Detailed instructions for hardware repairs, such as replacing fuses, filters, and disassembling unit components.

5.3 EXTENDED ACCESS FUNCTIONS

Procedures for accessing advanced functions like reading diagnostic indicators and installing options.

SECTION 6 SPARE PARTS CATALOGUE

6.1 SPARE PARTS LISTING

A list of all spare parts with their descriptions, reference numbers, and quantities, often accompanied by diagrams.

6.2 SPARE PARTS DETAILS

Detailed images and references for specific spare parts and accessories, aiding in identification and ordering.

SECTION 7 TECHNICAL MODIFICATIONS RECORD

7.1 MODIFICATION LOG

A record of technical modifications applied to the unit, detailing the change and its revision index.

SECTION 8 LIST OF DRAWINGS

8.1 SCHEMATIC DIAGRAMS LIST

An index of available technical drawings, including schematics for the CPU board.

Sagem Ultima 600 Specifications