40
IP65 PROTECTION RATING
The device is protected against the dust penetration (first digit 6) and against jets of water
(second digit 5). Suitable for outdoor use.
PROTECTION AGAIN ELECTRIC SHOCK
When the projector is powered by the mains with its specific external adapter, it must be
connected to a power supply system with efficient earthing. Moreover, it is recommended to
protect power supply lines of the product from indirect contact and / or shorting to earth by
using appropriately sized anti electrical shock switch.
CONNECTION TO THE MAINS
The electrical connection with its specific external adapter must be carried out by a qualified
electrician.
Ensure that the mains frequency and voltage correspond to those for which the external
adapter of equipment is designed, as shown in the electrical data label of the external adapter.
This label also shows the power consumption that is necessary to refer to evaluate the
maximum number of devices to be connected to the electricity line, in order to avoid power
overloading.
If the external power cord of this light is damaged, all the complete adapter + its cable directly
connected, must be replaced with an identical one, exclusively available from Your PROEL
dealer.
Never operate the equipment with lenses and / or covers missing or damaged.
In case of non-use, it is recommended to switch OFF the projector and unplug it from the mains
even if in charge.
MAINTENANCE
Before starting any maintenance or cleaning the product, disconnect the power from the
mains and disconnect the power cable from the device. After switching off, do not remove any
part of the device for at least 35 minutes to avoid the risk of burns. The lenses, if damaged,
must be replaced with original spare parts.
WARNING
CAUTION. Do not look directly at the light source. Do not look at the beam with lenses, glasses,
mirrors or similar optical instruments that could change the convergence of light, causing
serious damage to people and / or things.
To Next Page
Loading...