Sagitter FLOORBAT PLUS - Page 63

63
- OFF: display OFF after
seconds indicated in
SCREEN TIME function
Screen Time
10s…20s
(default 15s)
Backlight display OFF time
Screen Lock
OFF – 30s
OFF = screen not locked
30s = screen locked after 30
seconds. To unlock press
and hold ENTER button for
10 seconds
Current adj
(press and hold
ENTER for 10s)
(1)
Red
050 – 255
R current consumption
Green
050 – 255
G current consumption
Blue
050 – 255
B current consumption
White
050 – 255
W current consumption
Temp
(press and hold
ENTER for 10s)
10°C…85°C
(default 75°C)
Max temp reached before
power reduction
Find Me
(2)
OFF
Behaviour of the projector
in case of battery 5% or less:
- OFF: no function
- ON: Master dimmer = 255
– Blue color = 005
ON
White balance
(press and hold
ENTER for 10s)
(3)
Red
000 – 100
R intensity balance
Green
000 – 100
G intensity balance
Blue
000 – 100
B intensity balance
White
000 – 100
W intensity balance
Reset
Total Reset
ON / OFF
Total reset
Default
ON / OFF
Reset to factory settings
System info
Software V
X.XX
Version of the software
DMX Level
Dimmer
Automatic level of the single
DMX channels
Strobe
…
White
Temp
XX °C
Current temperature
Operate Time
XXXH
Total working hours
RDM
XXXX : XXXXXXXX
RDM code
Notes:
(1) After default reset, these values are all reset to 255
(2) The FIND ME function is useful if you need to place the projectors in dark places, where
it could be difficult to find them if the battery runs out. If this function is set to ON, when
the battery reaches a level lower than 20%, the projector automatically sets itself to a
fixed blue color, to make it easier to find it..
WARNING: if a Master / Slave chain is used, on the contrary, it is not suggested to set this function
in the Master, because if the master had a lower battery level than the Slaves and its battery level
reached 20%, the "FIND ME" function would be activated (as normal), but being the Master, it
would also send the command to the Slaves, which would all become blue, despite having a higher
battery level.
(3) After default reset, for convenience, these values don’t come back to default values.