Dear Customer,
We tried to achieve two targets when developing this product.
The rst was to produce the best quality heater on the market.
The second was to produce the most cost-eective heater. We
feel that we have achieved these two objectives however we
would be delighted to hear from you if you have any comments.
Thank you for purchasing one of the products in our range. We
wish you many enjoyable warm hours.
Yours Sincerely
Chairman
The 13kW patio heater is made by Universal Innovations to an
exacting quality standard and is covered by the following guarantee:
THIS PRODUCT IS FULLY GUARANTEED FOR 2 YEARS,
REGARDING PROPER USE.
This guarantee does not aect your statutory rights in any way.
HELPLINE Dublin Ireland
00 353 1 2873797
IF YOU NEED ANY ASSISTANCE PLEASE DO NOT HESITATE
TO CONTACT US DIRECTLY AT THE FACTORY. DO NOT BRING
GOODS BACK TO PLACE OF PURCHASE.
13kW Heat Focus Patio Heater
Assembly & User Instructions
2 Burner Gas Barbecue
13kw Patio Heater
For more information, contact Universal Innovations
w: www.uig.biz p: (00 353) (1) 2873797 e: info@uig.biz
This appliance is designed for external use only using Propane (G31) gas at a supply
pressure of 37 millibar and must be serviced by a competent person in accordance
with the instructions included. Please read all accompanying documentation carefully.
Technical Specications:
Overall Height: 2.13 meters approximately.
Gas Category: I3+
Overall Width: 865 millimetres approximately.
Heat input(·Qn): 13 KW Net. ( 44356 BTU/H )
Control Valve: Combined gas valve and ame failure device.
Setting Pressure: 37mbar
Main Burner Type: Pressed steel venturi.
Injector Size: 1.82 mm
Regulator Outlet Pressure
+ Type: 37mbar (27mm clip on)
Servicing Procedure:
Servicing to be carried out by qualied gas technician, every 100 hours of use.
• Remove regulator from cylinder.
• Remove reector “Parasol” Assembly.
• Remove “Burner” for examination and cleaning.
• Vigorously wire brush mesh inside and out to remove any clogging deposits.
• Remove windshield guard to expose main burner assembly.
• Examine, clean or replace main injector, ignition electrode, thermocouple and gas
pipe O ring as required. During storage, particularly, insects or foreign matter may
get into gas line/nozzle. Ensure that the gas line is completely clear before use.
Note: There are a number of ways to check the gas for leaks. We recommend a leak
detector spray or soapy water applied onto the joints with a small paint brush be used.
Leaks can be seen as small bubbles at the outlet point. DO NOT check for leaks using
a naked ame. Check the condition of the hose monthly and each time the cylinder
is changed. If the hose is in any way degraded, replace it immediately with the same
specication of hose. Hose length must be 150cm.
The product is fully guaranteed for 2 years regarding proper use.
For servicing contact your local gas supplier or phone
Calor Direct U.K. 0800 662 663. Universal Innovations Helpline 00 353 1 2873797
For further information on the heater and its parts, please contact the factory direct.
Helpline Hours, 9am - 5pm Mondays to Fridays. 00 353 1 2873797.
We are located at: Universal Innovations.
Kilcoole Industrial Estate, Kilcoole, Co. Wicklow, Ireland.
GUARANTEE
OTHER PRODUCTS IN OUR RANGE
TECHNICAL & SERVICING INFORMATION
0086
To Next Page
Need help?
General