SAHP - Installation Manual |5
V3 June 2021US - SD667052
HEALTH AND
SAFETY
2.7 Solar Assisted Heat Pumps must be stored in the supplied
packaging in an upright orientation and should be stored in a dry
environment. The equipment should always remain in an upright
position during transport and installation. If turned on its side,
return the box to the upright position, check the compressor for signs
of leakage and leave to rest for 12 hours, before turning the unit on.
SAHP declines any responsibility as regards damages deriving from
incorrect transportation.
2.8 If transporting in the horizontal orientation, ensure the unit is laid down
on it’s left hand side, so that the left hand side is facing the ground.
Failure to do so may cause permanent damage. SAHP declines any
responsibility as regards damages deriving from incorrect
transportation.
2.9 Care should be taken when moving the product. Check the weight
before any lifting. This is for the safety of the installer and customer.
Ensure the product is installed in a safe location and the mounting
structure is adequate to withstand the additional load. Take care when
moving the equipment to ensure there is no damage to the
iµÕ«iÌÀiÝÃÌ}ÃÌÀÕVÌÕÀi>`wÌÌ}ð
2.10 Safe manual handling and lifting procedures must be used when
carrying products.
To Next Page
Loading...
