IMPORTANT SAFETY INFORMATION
READ BEFORE USE
The following precautions must be observed when operating the
SmartCharger. To reduce the risk of electric shock, fire or
injury,
pleas*
read the points below before using the unit, and follow the rules during
use. Failure to observe these safety rules will render the warranty void
USING THE SMARTCHARGER
• Place the SmartCharger on a dry, stable surface when in use. Do not position
th<
unit above a heater or a heating vent. Do not place the unit where it can fall into
or come into contact with water. Do not place the unit on a vibrating surface such
as a washing machine.
• If the unit comes into contact with water or any other
liquids,
immediately unplug
your SmartCharger. Do not remove the unit from the liquid until you have done
so.
• Do not place anything over the SmartCharger during use. Never drop anything
onto the unit.
• Do not use any adapter other than the one supplied by the manufacturer.
The use of any other adapter renders the warranty void.
• Do not use extension cords or plug adapters with this unit.
• The use of any attachments not intended for this battery charger may
involve the risk of
fire,
electric shock or other personal injury.
• Do not disassemble the charger. It should be serviced or repaired by
qualified service personnel only. Incorrect assembly may result in an
electric shock or fire.
• Do not alter the provided AC-DC adapter in any way. If it does not fit
into an AC outlet, have a qualified technician install the proper outlet.
An improper connection may result in an electric shock.
• Never use the charger as a DC power source for any electrical equipment.
• The SmartCharger is for indoor use only. Do not expose it to rain or
excessive moisture.
• Do not use chemical agents to clean the SmartCharger or adapter. Before
cleaning the charger, disconnect the charger from the AC-DC outlet. Clean the
metal contact with a soft cloth only.
• Check the SmartCharger and the AC-DC adapter regularly. Do not use the
unit if there is any sign of damage.
• The SmartCharger will not recharge dead or almost-dead batteries.
BATTERY SAFETY RULES
• Only recharge AAA,
AA,
C,
D, Prismatic size 1.2V and 9V
(6F22/1604)
Ni-Cd/Ni-MH batteries. Do not attempt to recharge Lithium batteries or any
other type of battery.
• Do not try to recharge batteries that are
rusty,
corroded, damaged or leaking.
• Remove rechargeable batteries from electrical equipment before charging
them.
• Make sure the polarity marked on the rechargeable battery matches the
polarity marked in the SmartCharger compartment.
STORING THE SMARTCHARGER
• Remove all the batteries before disconnecting the adapter from the unit.
• Check the AC-DC adapter regularly. Replace the adapter if damaged.
• Always unplug the SmartCharger after use and store the unit in a dry place.
• Disconnect the charger by pulling the plug rather than the cord to reduce
the risk of damage to the AC-DC adapter.
SAVE
THIS INFORMATION FOR FUTURE
REFERENCE
NOTE: PLEASE CHECK ALL PACKAGING BEFORE
THROWING AWAY
ENCLOSED YOU SHOULD FIND:
1 main unit
2 prismatic battery adapters
1 AC-DC adapter
1 instruction manual
To Next Page
Loading...