EasyManua.ls Logo

Saivod SAPH98 - Maintenance and Cleaning Procedures

Saivod SAPH98
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
39
Sleeping mode
Press key “SLEEP” on the remote control enter into sleeping mode, default value of fan
speed is low.
When sleeping mode turns on , under cooling mode, the first one hour later, setting
temperature will go up 1, the second one hour later, setting temperature will go up another
1, and then keep the same .
Sleeping mode is invalid under dehumidifying and fan mode. Under water full, machine
standby and mode conversion, sleeping mode will be cancelled .
Compressor protection
Three minutes later after power on / restart, compressor starts to run.
Water Drainage
This machine with auto-water-evaporating system. Condensed-water cycle to cool down the
condenser, which will not only improve cooling eciency, but also save energy.
If inner water tank is full, “W.F” indicator will flashed on the screen , 8 seconds later
machine enter into standby mode, buzzer shouts , compressor stops and all keys is invalid till
machine recovers to be normal .
Pull out the plug to drain out water, power o the machine and restart it , the machine will
runs normally .
Maintenance
Note: in order to avoid electric shocks, please power-o the machine and pull out plug be-
fore maintenances or repairs.
Cleaning
Please pull out plug before cleaning .
Use soft semi-dry cloth to clean the machine. Don’t use chemical agents, such as benzene,
alcohol, gasoline and so on ; otherwise the machine surface will be damaged, or even the
machine itself.
Don’t spatter water into the machine .
Filter
Clean the filters every two weeks, if filters are blocked by dust, machine eciency will be
reduced .
Clean the filters in warm water with neutral detergent, then dry the cleaned filters on a
shady place.
Note: Don’t run the machine without filters.
Season Cleaning
If the machine will be unused for a long time, please do as following :
Pull out drainage plug upper / lower to flow out water.
Let the machine runs under fan mode for 2 hours to dry out the machine internal.
Turn o machine and pull out plug .
JHS.indd 39 2018/1/24 17:10:14

Related product manuals