Salamander Designs SYNERGY 402 User Manual

BEFORE YOU BEGIN:
• Unpack all parts before beginning and refer to the drawing below.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
They cannot be removed individually without disassembling the whole unit.
SYNERGY 402
Single Instructions
Includes:
(1) Single 40 Unit
(2) S40 Side Panels
(1) S40 Door
!
!
Limited Warranty
For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment conse-
quential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging
shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only. Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com
©2002 Salamander Designs Ltd.
Top Shelf (1)
Adjustable Shelf (4)
Bottom Shelf (1)
Joint Connector Bolt 300-540 (4)
Foot & Nut P-300-350 (4)
Door (2)
Aluminum Post (4)
Sides (2)
Washer 300-470 (4)
Shelf Peg
PHK-370 Right (8)
PHK-380 Left (8)
Doc No. 500-650/v11.12 402 -1/4

Salamander Designs SYNERGY 402 Specifications

General

Brand	Salamander Designs
Model	SYNERGY 402
Category	Indoor Furnishing
Language	English

Summary

Before You Begin

Limited Warranty

Connect Posts to Bottom Shelf

Square Post

Ensure the post is square to the bottom shelf for stability and proper alignment.

Connect Post

Attach the post to the bottom shelf using the provided foot, washer, and hex nut.

Add Shelf Pegs & Door Hinges

Group Shelf Pegs

Identify and understand the two varieties of shelf pegs (A and B) designed to cradle shelves.

Insert Hinges & Add Shelf Pegs

Slide hinge plates into post channels and insert shelf pegs, then tighten securely.

Attach Door

Attach Hinges to Door Frames

Insert and lock hinges into the door frame holes, turning screws 1/4 turn to the right.

Adjust Clearance

Ensure doors are 1/8" above the bottom shelf before fully tightening hinges to the post.

Rubber Stops

Attach rubber stops inside the door frame where they contact shelf pegs during closing.

Door Pull

Screw the door pull into its designated place on the door.

Attach Rear Panels

Insert Hardware

Combine threaded studs with flat nuts and slide them down the posts at specified locations.

Position & Secure Studs

Align studs at the top and bottom of posts using the Spacer Tool for correct spacing.

Place Rear Panels

Secure each rear panel in place using thumb nuts.

Adjustable Shelves

Placing & Adjusting

Place shelves from the bottom up, angling them onto pegs and using the Spacer Tool for alignment.

Fine Tuning

Use a bubble level to precisely adjust shelves for flatness and levelness.

Insert Side Panels

Secure Top