Saleen VI Series User Manual

SALEEN SERIES VI SUPERCHARGER FOR 2005-07 MUSTANG
MAINTENANCE SCHEDULE
Very little maintenance is required for your Series VI supercharger. There are two key
fluids involved in the kit which you should pay attention to. Please hold on to the
installation manual for the supercharger kit to aid in the location and identification of the
components
1. The oil in the front (gear case) of the supercharger is refilled via a brass plug on the
driver’s side. The plug is underneath the water crossover of a completely installed kit. The
supercharger takes a full pint of oil. The oil that the supercharger is delivered with will last
50,000 miles. A 5W-50 oil may be substituted but will need to be changed every 5000
miles. When changing the oil, be sure to completely siphon all of the oil out of the gear
case.
2. The supercharger kit comes complete with an independent coolant system. Regularly
check the fluid level of the intercooler system. The fluid should reach the bottom of the
neck of the recovery tank when the system is cold. With the water pump on (key on or car
on), check as often as every couple of oil changes that the fluid is circulating. If it is not,
purge the system per the instructions in the supercharger installation manual.
Change the fluid in the intercooler system as often as the radiator fluid is changed, using a
50/50 mix of antifreeze and water.
If you have any questions, please call Saleen at 248-743-4800.
*note: there is no warranty on the supercharger in the aftermarket unless supplied by the
installer.

Saleen VI Series Specifications

General

Brand	Saleen
Model	VI Series
Category	Automobile Parts
Language	English

Summary

Saleen Supercharger Maintenance Schedule

Supercharger Gear Case Oil Service

Guidance on refilling and changing the supercharger gear case oil, including capacity and type.

Intercooler Coolant System Check

Procedures for regularly checking and changing the supercharger intercooler coolant level and fluid.

Saleen PCM Communication and Calibration

PCM Identification and Re-programming Policy

Details unique PCM ID numbers and the requirement for Saleen to perform all re-programming.

Diagnostic Trouble Code P0605 and Program Integrity

Explanation of the P0605 DTC and the critical warning against altering the Saleen PCM program.

Understanding Twin-Screw Supercharger Rotor Clash

Rotor Clash Noise Characteristics Explained

Defines 'rotor clash' noise in twin-screw superchargers and normal operating conditions.

Supercharger Assembly Quality Assurance

Outlines the examination and pressure testing procedures performed on superchargers before shipment.

Saleen Supercharger Warranty Service

Warranty Return and Repair Procedures

Guidelines for manifold assembly removal for warranty returns and repairs; warnings against unit disassembly.

Locating Supercharger Oil Level Check Point

Identifies the specific location for checking the supercharger oil level on an installed unit.