5.Removing the battery from the camera.
6 Start to use
1. Charge the built-in lithium battery
The camera is equipped with built-in 3.7V lithium battery. Please ensure power available
for the camera and timely charge it in case of low battery.
Connect the camera to computer for charging under shutdown status. The charging
indicator will be on when charging, and will be off when the battery is fully charged.
Generally, the battery can be fully charged after about 4 hours.
Note: when the DV is on, it will not charge until the DV turn off.
2. How to use the memory card
2.1. Properly insert the TF card into the card holder as per the instructions indicated near
the card holder.
2.2. To remove the TF card, press the end of memory card gently, the card will be ejected.
To Next Page
Loading...
