Salora CDC1300FD - Initial Settings and Recording; Initial Settings; Recording Operations

37
5. Put the device On/Off
(1). Auto On/Off: once the car engine is started, the device will automatically boot. Once you put the
device on, the camera will automatically start recording. If the car engine stops, the device will save
the record and the power will be turned off, within 15 seconds.
(2). Manual on/off: if you want to put the device on manually, you press the
key, press again and the
device will be turned off.
Initial settings
Set the date and time:
1. Press the OK key to put the device into the standby state.
2. Press the M key twice, and choose < time/date>, by pressing the
and keys, then press OK to
enter the setting
_________________________________________________________________________
3. By pressing the
and keys, you can adjust the values, after each eld you press the OK key to
conrm, until you have completed your setting. Press M to exit the menu.
Recording Operations
1. When the car engine is started, the device will automatically be turned and start recording. When
the engine is stalled, the camera will stop recording. You can also pres the OK key to stop recording
manually.
Note: In some vehicles the, although the engine is stalled, the power supply will continue. If so,
you can stop the camera manually or you can pull out the plug of the cigarette lighter.
2. Other types of camera: press the OK key, the recording will start, press the OK key again to stop
recording.