Problem Solution
No sound
• The station is not tuned in. Fine tune the station.
• The volume is set to a low position. Increase the
volume.
• Headphones may be connected. Disconnect the
headphones.
Buttons are not
working
T
urn off the unit and turn on after a few seconds.
FM: Static sound
DAB+: Burbling/
intermittent cut-out
• Signal reception is too low
. Adjust the aerial or
move the unit to a stronger signal location.
• Rescan stations.
Sound is distorted The volume is too high. Adjust the volume control.
Desir
ed station not
found
Weak signal. Use the manual tune function.
Display shows
“No Service”
There is no DAB+ coverage in your ar
ea, or poor
reception. Adjust the position of the aerial, or
move the unit to a stronger signal location.
Display is blank This may occur if the broadcaster changes the
label of a service or removes a label while tuned.
The radio will try to retune or perform a scan.
FAQ
s
14
To Next Page
