Operators And Parts Manual-Model HP5.5 Gas Greens Roller 2/17/2021 - 6 -
SERVICE & MAINTENANCE INSTRUCTIONS
1. Check all hydraulic hoses DAILY, or before each scheduled use, for wear and any signs of rubbing
or chaffing. REMINDER: Drive motor hoses should be treated as wear items and should be
replaced on a yearly basis.
2. Check all fittings for any signs of leaking DAILY, or before each scheduled use.
3. Check all grease fittings on a WEEKLY basis, and grease as necessary. (Add ½ shot of grease in all
four bearings.)
4. Check engine to manufacturers’ specifications and maintenance. USE CORRECT OIL. (Per Honda
Manual).
5. Check hydraulic oil (use correct oil per decal).
6. Check Fuel NEVER fill a HOT engine.
7. Slide fuel shut off towards the engine. Always shut off the fuel when unit is NOT in use.
8. Slide choke away from engine till engine starts then turn choke off allowing engine to warm up.
9. When transporting unit from green to green be sure to turn off fuel.
10. Oil & Filter Type – It has been determined that your Salsco machine will perform better by using a
25 micron filter. Salsco recommends using Mobil DTE 26 or Citgo HYD 68, non-detergent hydraulic
oil, or their equivalents. The oil should have a viscosity rating of at least 100 SSU. While this is not
a necessity, it will improve the overall performance of your machine. Salsco is now using this filter
and hydraulic oil on all our machines using hydraulics.
SAFETY IS A PRIME CONCERN AT SALSCO AND THE SAFETY DECALS ON YOUR
MACHINE ARE A HIGHLY VISIBLE AND CONSTANT REMINDER TO ALL OPERATORS.
REPLACEMENT SAFETY DECALS MAY BE OBTAINED BY CALLING SALSCO @ 1-800-872-
5726, OR THE DEALER IN YOUR AREA.
05/2013
To Next Page