4. Screw the Lid and Motor Assembly onto the Blending Cup and
double-click the On/O button to begin blending. The Indicator
Light will turn blue and ash 6 times to indicate that the Lid is in the
correct position. NOTE: If the Indicator Light turns red and ashes
six times, or if the blender does not start, ensure that the lid is
correctly positioned and double-click the On/O button.
5. Hold blender upside down during operation and shake gently to
blend food and liquid. The blending cycle will stop automatically
after 40 seconds.
6. Return to upright position and shake. If desired consistency is not
achieved, repeat steps 1-5.
7. Once blending is complete, the blender’s lid can be removed and
the blending cup can be used to directly consumer your juice,
smoothie, etc.
NOTE: Should you wish to stop the blending cycle at any time, press
the On/O button once.
CARE AND CLEANING
1. Clean the Blending Cup in warm soapy water. Use a soft sponge or
cloth and soapy water to wipe down the Lid and Motor Assembly.
2. Thoroughly rinse Blending Cup and Lid and Motor Assembly. DO
NOT immerse Lid and Motor Assembly in water.
3. Wipe dry all parts or allow to air dry before storing the blender.
NOTE: Handle with care as the blades are sharp.
4. Ensure blender is clean and completely dry before storing in a dry,
ventilated area away from direct sunlight.
Rapid Clean
Add water to the blending cup. Do not exceed 300ml. Double-click
the On/O button, turn the blender upside down and allow blender to
complete one blending cycle.
4
To Next Page
Loading...