Salus KL08RF User Manual

KL08RF
Installation and Wiring Guide
www.salus-controls.com Technical Helpline +44 (0) 1226 323 961
GROUP 2
GROUP CONTROL
THERMOSTAT
MAINS POWERED
(MODEL VS10WRF)
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS20WRF)
GROUP 1
THERMOSTAT
(VS20WRF)
GROUP 1
THERMOSTAT
(VS20WRF)
GROUP 1
THERMOSTAT
(VS10WRF)
GROUP 2
THERMOSTAT
(VS10WRF)
GROUP 2 CONTROL
THERMOSTAT
(VS20WRF)
GROUP 1
STANDALONE
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL
VS10W
(M
ODEL VS20WRF
)
WRF)
WRF)
SUPPLIED CABLES
230V TO UFH PUMP
UNDERFLOOR HEATING MANIFOLD
1.5MM
2
CABLE
(INSTALLER SUPPLIED)
Optional boiler connection
NL
External power supply
NL
These instructions apply to the SALUS model stated above.
Warning
This product must be tted by a competent person, and
installation must comply with the guidance, standards and
regulations applicable to the country or state where the
product is installed. Failure to comply with the requirements
of the relevant guidance, standards and regulations could lead
to injury, death or prosecution.
Warning
Always isolate the AC mains supply before installing or working
on any components that require 230 V AC 50Hz supply.
For PDF Installation guide go to www.salus-controls.com
Meets the following EC Directives
• Electro-Magntic Compatibility directive 2004 / 108 / EC
• Low-voltage Directive 2006/95/EC
Optional wireless
receiver RX10RF
Maintaining a policy of continued product development SALUS Controls plc reserves the right to change
specication, design and materials of products listed on this installation guide without prior notice.
Issue Date: October 2014 Document Number 00106
Warning
The earth terminals on the KL08RF are for earth parking only.
These terminals provide no earth protection.
iT600 Wiring Centre KL08RF 028 V9.qxp_Layout 1 04.12.2014 12:30 Strona 1

Salus KL08RF Specifications

General

Temperature Range	5 - 35 °C
RF Frequency	868 MHz
Communication	RF
Range	Up to 30 m
Batteries	2 x AA
Display	LCD
Operating Temperature	0°C to 40°C

Summary

Product Overview and Safety Information

EC Directives Compliance

Details the product's compliance with EC Electromagnetic Compatibility and Low-Voltage Directives.

General Safety Warnings

Highlights crucial safety precautions for installation and use, including isolation of mains supply.

Installing and Connecting the KL08RF

Physical Installation and Wire Preparation

Covers physical mounting, cover removal/replacement, and preparing power/connection board wires.

Wiring Connections and Optional Antenna

Details connecting thermal actuators, pump, boiler, CO, dew point wires, and optional external antenna.

Configuration and Network Pairing

Explains jumper settings for delays, actuator types, and pairing the KL08RF to the wireless network.

LED Indicators

Provides a guide to understanding the status indicated by various LEDs on the KL08RF unit.