SUN_IS_ electrical_installation_v5.1_06092021
35
4. Using the light switch, check the operation of the LED bench backlight.
5. Unlock and press the SOS button – make sure you can hear the emergency siren.
6. Heat the air with a lighter around the HUMM temperature sensor to verify its operation. The
temperature shown on the display should increase when heated.
7. Check the operation of the door closure sensor. The display will go out "DOOR OPEN" when
the door is closed.
8. Check the operation of the furnace installation "5", to do this press the round button.
NOTE: The door must be closed to perform the test.
To Next Page
Loading...