Need help?Do you have a question about the Salus SunCube and is the answer not in the manual?
General| Brand | Salus |
|---|---|
| Model | SunCube |
| Category | Plumbing Product |
| Language | English |
Prepare harness "1" and associated wires, including cutting, stripping, and routing into protective pipes.
Install the control box and route the main harness "1" through the sauna structure to the fuse box.
Install the protective pipe for the HUUM temperature sensor by drilling holes and securing it.
Lay the LED light wiring conduit through the sauna structure and prepare mounting holes.
Mount the SOS button box and the SOS button base to the sauna paneling.
Measure, drill, and install the light switch box into the sauna's wooden paneling.
Drill precise holes in the door frame for the door opening detector wire installation.
Assemble and connect LED strips, including soldering and securing wires under the bench.
Prepare and mount the alarm siren, connect its wiring using WAGO connectors.
Mount the HUUM temperature sensor by drilling, screwing, and leveling it onto the paneling.
Install the HUUM door opening sensor, connect its wire, and secure it to the door frame.
Mount the Wi-Fi HUUM controller, connect wires, and fasten it to the sauna paneling.
Connect wires to the LED light switch and mount the switch assembly into its base.
Connect the SOS siren wiring within the control box as per instructions.
Connect the SOS button wiring within the control box, ensuring proper continuity.
Connect the power supply for the LED strips within the control box.
Prepare and connect the HUMM control unit to the installation inside the control box.
Connect the HARVIA furnace installation to the control box wiring.
Conduct final tests on all electrical connections and component operations.
To Next Page