SUN_IS_ electrical_installation_v5.1_06092021
32
9. Check all wire connections to the control panel. If necessary, tighten the wire fixing with a
screwdriver.
10. Replace the cover and fasten it with the screws provided. Write the sauna's serial number on
the cover with a marker and take a photo of the label. Send the photo to:
radoslaw.wojcik@suncubesauna.com
E. Connecting the HARVIA furnace installation
1. Remove the red cables from the contactor. One of them is bridged to the black wire,
cut it off, and put a cable lug on it.
To Next Page
Loading...