SUN_IS_ electrical_installation_v5.1_06092021
18
VIII. ASSEMBLY AND CONNECTION OF LED INSTALLATION (RIGHT AND LEFT SIDE)
1. Put heat shrink tubing over both wires of the right LED harness "4", then connect the wires from
the LED strip to the wire from the harness and solder them together using a transformer
soldering iron.
2. Using a cigarette lighter, secure the wire connections.
3. Glue the ends of the LED strip on both sides using universal silicone.
4. Hide the wire under the paneling. To do this, pull back the bench backrest (mounted on 2 working
nails – once the installation is in place, the bench backrest is nailed down according to the bench
and backrest installation instructions).
To Next Page
Loading...