Sam4POS KP Routing Supplement v2.1 - 16 - Table of Contents
KP Group (v1.0.80 and Later)
The KP Group programming was changed beginning at v1.0.80 and later. Use this programming area to
determine the KP Groups that will be used for assignment in the PLU Status Group programming. You can
assign KP Groups to different printers at different time periods if desired.
Note: You must create a KP printer in the Device Mapping before you can create a KP Group.
Note: KP Time Periods must be created prior to assignment here.
1. From the Program Mode/Device menu, select KP GROUP from the available selections.
• Alternately, you can press the drop-down arrow on the /DEVICE MAPPING screen to view
the sub menu selections; then select KP GROUP from the selections.
2. The KP GROUP program screen is displayed:
3. From the KP GROUP programming screen press the icon in the LEFT COLUMN to add a new KP
Group(s) or select a KP Group list.
4. Input a description (up to 30 characters) for the KP Group and press OK to close the dialog or press OK
AND CONTINUE to add additional KP Groups. Press CANCEL if you wish to exit the add KP Group
without adding the group.
5. After the KP Groups are created, press the icon in the C
ENTER COLUMN to assign the printer to be
used for the KP group and selected the time period for the group.
6. When the printer and time period are selected, the KP OPTION selections are displayed.
To Next Page
Loading...
