Sam4POS KP Routing Supplement v2.1 - 5 - Table of Contents
DeviceProgramming:
Device programming is where all the individual printers to be used on the Sam4POS system are configured
and mapped (routed) to the all the stations in the system. The KP Group programming is also setup in this
area.
Device Setting
The Device setting program area is where all your printers are configured for the port that they will occupy.
Each terminal will have its own device setting programming. To simplify device mapping when multiple
terminals are in an IRC network, it is best to program your devices to the same port on each Sam4POS
terminal. For example: all Grill Printers on COM2, all Beverage printers on COM1, etcetera.
The SAP-530 Sam4POS terminals have a standard internal receipt printer, additional serial or ethernet
printers can be connected as needed.
1. From the PROGRAM MODE main menu selection screen select DEVICE to view the Device menu
selection dialog, then select DEVICE SETTING. The DEVICE SETTING program screen displays:
2. Choose PRINTER from the device selection list. Current printers installed on the terminal are listed.
3. Press the icon to add a new device to add a new printer. The add new printer dialog displays:
To Next Page
Loading...
Need help?
General
