Need help?Do you have a question about the Samon GD and is the answer not in the manual?
General| Brand | Samon |
|---|---|
| Model | GD |
| Category | Gas Detectors |
| Language | English |
Specifies placement dimensions (X, Y, H1-H3) and gas types (NH3, CO, HFC) for GD, GS, and GSR detectors.
Details connection fittings for GR detectors, specifying 'R' for NH3 and 'Flare' for HFC.
Outlines the mounting requirement for GK detectors: X dimension must be greater than 5 times the D dimension.
Lists factory-set alarm levels (A, B, C) for Ammonia, HFC/HCFC, Exhaust Gas/VOC, and Explosive Gas.
States conformity with LVD and EMC directives and lists applicable standards for the GB region.
States conformity with Low Voltage and EMC directives and lists applicable standards for the D region.
States conformity with LVD and EMC directives and lists applicable standards for the ES region.
States conformity with DBT and CEM directives and lists applicable standards for the FR region.
Describes power-on sequence, LED indicators (green, yellow, red), and alarm level detection.
Explains automatic/manual reset via DIP switch and alarm time delay (T1) settings.
Details the self-test function using the service button and behavior during fault conditions.
Covers service function for disabling alarms, installation, calibration, and annual testing.
Provides housing material, power supply, consumption, outputs, ambient temperature, and humidity.
Highlights high voltage under the lid and that sensors are not gas-specific, advising on cross-contamination.
To Next Page