Description of the rotary switch LEDs
The table below shows the value of the selected parameter and the corresponding voltage value. Each LED corresponds
to a different parameter. The default parameter values are saved to permanent memory.
Warning level.
The operator can set the warning threshold.
See the table below for the voltage value corresponding to the selected setting.
Alarm level
The operator can set the alarm threshold.
See the table below for the voltage value corresponding to the selected setting.
Modbus address
The operator can set the Modbus address.
To set the values with greater precision, use the Modbus serial connection or app. See the table below for
the voltage value corresponding to the selected setting.
Alarm delay
The operator can select the delay time for activation of the LED and the alarm relay after the alarm threshold
has been exceeded.
See the table below for the voltage value corresponding to the selected setting.
Type of analogue output voltage.
The operator can select the type of analogue output.
See the table below for the voltage value corresponding to the selected setting.
Alarm/warning reset function mode
This parameter is used to select the warning and alarm reset modes. 0 = manual reset (latch) / 1 = automatic
reset
Modbus configuration
The operator can choose the desired Modbus configuration from the options available. See the table below
for the voltage value corresponding to the selected setting.
Possible configurations - Alarm/warning reset function mode (W7)
To Next Page
Loading...