Samson C01U - Getting Started: Windows 7 & Vista Setup

CO1U - USB Studio Condenser Microphone -
Getting Started with Windows 7 & Vista
The following example is for setting up
the CO1U in Windows 7 and Vista.
i
The first time you plug the CO1U
into a USB port, Windows 7 or Vista
will install the universal drivers for
that port. A balloon will pop up,
telling you the computer has found
the CO1U.
When it is finished installing the
drivers, a balloon pop up will say
“Your device is installed and ready
to use.”
Note: This balloon will only pop up
when you first plug the device into a
particular USB port.
To set the CO1U as your default
device for recording, or to change
its settings, click the Start button,
click Control Panel and then click
Sound. Under the Recording tab, you
can select the SAMSON C01U from
the menus and use the Set Default
button to set it as the default device
(figure 1).
To set the gain of the microphone,
click the Properties button, and then
select the Levels tab. You can choose
to view the Microphone volume
level as either a percentage or in dB,
by right clicking on the number box
(figure 2).
ms
al
t
[[Playback| Recording | Sounds: Communications
) Select a recording device below to modify its settings:
} |
| ”
| ty) Not plugged in
|} | -
]
Microphone | |
Realtek High Definition Audio | }
|
|
Microphone
SAMSON CO1U
Detauit Device
Figure Zz
ESPANOL | DEUTSCHE | FRANCAIS | ENGLISH
°
zZ
=
4
E