PRO
PRODUCT SPECIFICATION SHEET
MICROPHONES
PRODUCT DESCRIPTION
CM15P / CM20P
GOOSENECK PODIUM MIC
SERIES
CATEGORY
INSTALLATION MICS CONDENSOR MICS
GENERAL DESCRIPTION
The CM15P and CM20P miniature gooseneck
microphones are 15" and 20" in overall length
respectively, and the goosenecks are flexible at the
top and bottom with a mid-section stiffener for a
straight profile. They feature a permanently charged
condenser element with a Cardioid (uni-directional)
pick-up pattern, providing good off axis response
while maintaining high feedback rejection. The
CM15P and CM20P microphones are fitted with a
standard 3-pin male XLR connector at their base for
easy installation on standard female XLR connectors
or cables. An onboard High-pass filter, at 100Hz, is
included, allowing the low frequency response to be
attenuated which helps remove background noise,
stage rumble and mechanical noise, which can
sometimes be transmitted by the speaker at a podium.
The microphones operate on a standard 9 through
52 volt phantom power supply. Each microphone
includes a standard and shock-mounted flange for easy
installation. A dual-stage, rippled windscreen is also
provided to greatly reduce annoying P-popping. The
microphone elements are protected by rugged metal
housings and the entire microphone is finished in a low
reflectance, matte black finish.
FEATURES
> CM20P: 20" overall length; CM15P: 15" overall length
> Flexible gooseneck top and bottom, rigid mid-section
> Internal selectable Hi-pass filter
> Standard XLR connector
> FMS1 Standard Flange-mount & SMS1 Shock-mount included
> WS15 Multistage windscreen included
> 9 – 52 Volt Phantom Power Operation
ARCHITECT’S & ENGINEER’S SPECIFICATIONS
The Samson CM15P shall be a podium microphone. It will be
available in black. It shall be 15 inches long and be flexible
at top and bottom. It shall be a cardiod pattern condenser
microphone element type and require between 9 and 52 volt
phantom powering. The CM15P shall plug into an included
flange mount for mounting to a podium.
The Samson CM20P shall be a podium microphone. It will be
available in black. It shall be 20 inches long and be flexible
at top and bottom. It shall be a cardiod pattern condenser
microphone element type and require between 9 and 52 volt
phantom powering. The CM20P shall plug into an included
flange mount for mounting to a podium.
CM20P / CM15P SPECIFICATIONS
Element Type ................................... Fixed-charge condenser
Polar Pattern ................................... Cardioid (Uni-directional)
Frequency response ......................... 60 - 16000Hz
Sensitivity ....................................... -40dBV/Pa
Rated impedance ............................. 600 ohms
Max. SPL ......................................... 127dB
Dynamic range ................................. 103dB
S/N ratio ......................................... 70dB
Power Supply ................................... 9~52V phantom supply
Power consumption .......................... 4mA
TYPE:
GOOSENECK/
BOUNDARY/CHOIR
©2006 Samson v1.0 5/06
To Next Page
Need help?
General
Weight and Dimensions
