5. Adjustment of paddles
Remove both mounting screws on the rear panel and remove the chassis from the case. The pad-
dle uses silver-contacts. The gap of either dot or dash side is adjustable by means of two milled
screws.
The tension is adjustable by means of a single setscrew using an alien wrench for both dots and
dashes. (Fig. 1)
6. Connecting the key with the transmitter
Connect pins 2 and 3 of supplied DIN-connector with the keying input of the transmitter. Use
shielded cable and connect the shield to the above pin 2.
To Next Page
Loading...