Expedition Express+ • Portable PA System 9
Quick Start
XPD Wireless Input (sold separately)
• Plug the XPD USB receiver into the XPD
Wireless USB jack.
• Turn the MIC/LINE VOLUME knob on the
Express+ completely counterclockwise to 0.
• Place a fresh set of AA (LR6) batteries in the
transmitter battery holder, taking care to observe
the polarity markings, then replace the cover.
• Turn on the power to the transmitter by pressing
and holding Power switch; the indicator LED will
light amber.
• Speak or sing into the mic at a normal
performance level and raise the MIC/LINE
VOLUME control until the desired level is
reached.
Bluetooth®
• Turn the BLUETOOTH VOLUME control down
counterclockwise to 0.
• With the Express+ and your Bluetooth device
powered on; press the PAIR button on the rear
panel of the Express+ to make the speaker
discoverable. The Pairing indicator will slowly
flash blue.
• In the settings of your Bluetooth device, set it to
“discover” available devices.
• From the Bluetooth device list, select the
“Express Plus” device.
• If your device asks for a passkey, enter digits
0000 (four zeros) and press OK. Some devices
may also ask you to accept the connection.
• The Express+ speaker indicates that pairing is complete when the indicator turns
steady blue. You can now stream audio from your device to the Express+ speakers.
• With the volume control on your Bluetooth device turned up, play some music, and
slowly raise the Express+ LINE/BLUETOOTH VOLUME control until you have reached
the desired level.
To Next Page
Loading...
