Need help?Do you have a question about the Samson Hartke Systems 7000 and is the answer not in the manual?
General| Brand | Samson |
|---|---|
| Model | Hartke Systems 7000 |
| Category | Musical Instrument Amplifier |
| Language | English |
Connect passive bass guitars to the 1/4" unbalanced jack with high impedance input sensitivity.
Connect active bass guitars to the 1/4" unbalanced jack with high impedance input sensitivity.
Adjusts tube preamplification for classic amplifier sound; avoid maximum settings for distortion.
Adjusts solid state preamplification for modern amplifier sound; avoid maximum settings for distortion.
Indicates compression status: green for off, unlit for 2:1 ratio, red for limiting.
Adjusts compression amount (peak signal reduction) from 2:1 to infinity (limiting).
Activates or bypasses the graphic equalizer circuitry for custom equalization curve presets.
Ten sliders for boost/attenuation of 10 narrow frequency bands to shape tonal response.
Broad-band low frequency equalizer providing 18 dB boost/attenuation at 100 Hz.
Broad-band high frequency equalizer providing 18 dB boost/attenuation at 10 kHz.
Sets the overall output volume of the amplifier for desired sound level.
Determines cutoff frequency for bi-amping speaker outputs, from 20 Hz to 2.5 kHz.
Adjusts relative signal levels between Low and High frequency speaker outputs.
Indicates when the Model 5000/7000 is powered on.
Turns the Model 5000/7000 amplifier on or off.
Contains fuse holder and shows selected voltage rating; ensure correct setting before powering.
Connect the supplied standard 3-pin 'EEC' plug for AC power connection.
Outputs frequencies above crossover setting for smaller speakers in bi-amp mode.
Outputs frequencies below crossover setting for larger speakers in bi-amp mode.
Provides vital cooling; ensure it is unobstructed and has access to fresh air.
Sends low impedance signal to outboard effects processors or mixing consoles.
Returns low impedance signal from outboard effects processors.
Activates or bypasses crossover circuitry for mono or bi-amp speaker configurations.
Selects routing point for Direct Out signal: before or after EQ and compression.
Engages ground lift to eliminate hum or buzz from the Direct Out signal.
Electronically balanced XLR output for routing signal to mixing consoles or PA systems.
Low Pass and High Pass Contour controls adjust broad frequency bands for tonal shaping.
Ten narrow frequency bands with sliders for precise tonal response adjustment.
Adjusts compression amount, affecting peak signal reduction and dynamic range.
Visual indicator of compression activity, showing status from none to limiting.
To Next Page
