EasyManua.ls Logo

Samson L2400 - Page 18

Samson L2400
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
14 - GROUP OUT - XLR 1/4" jacks
In a live sound application, you can connect
additional zone speaker systems using GROUP OUT
outputs connected to a power amplifier or powered
speakers. The signal at the GROUP OUT jacks follows
the GROUP volume fader.TRS phone jack connector
pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
15 - GROUP INSERT - 1/4-inch Send and Return
jack
Send and return patch point on TRS (TIP/RING/
SLEEVE) jack for interfacing external effects
processors on GROUP bus outputs. The signal is sent
on the tip (the Send) and returns (the Return) on the
ring of the connector.
16 – AUX RETURNS
The L2400 and L3200 have two pairs of 1/4-inch
jacks for connecting stereo line level sources like
those from the outputs of effects processors. The
LINE inputs have a nominal operating level of -
40dBV through - 10dBV. TRS phone jack connector
pin-out - Sleeve: Ground, Tip: Hot (+), Ring: Cold (-)
17 - AUX OUT (1 and 2) - 1/4-inch jacks
The signal present at the AUX 1and Aux 2 outputs
are sent from the AUX 1 and AUX 2 bus, which is
fed from the AUX 1 and AUX 2 control knobs on the
input channels. The AUX 1 and AUX 2 are normally
used as a MONITOR MIX bus in a live sound situation
by connecting the output to a power amp and
monitor speaker. TR phone jack connector pin-out
- Sleeve: Ground, Tip: Hot (+).
18 - CD/TAPE Inputs - RCA jacks
The L Series mixers feature a stereo line level input
on RCA connectors for connecting the output of
devices such as MP3, CD, computer soundcard,
cassette player, or any other line level device.
19 - Record Out - RCA jacks
The signal present at this connector is the MAIN bus
signal before it has passed through the MASTER
level control and graphic equalizer. The nominal
output level is -10dBV and the impedance is 100
Ohms.\
20 - EFX OUT 1 -2 - 1/4-inch jack
The EFX OUT 1 -2 output is used to send a signal
to an external signal processor such as a delay
or reverb. The signal present at the EFX OUT 1 -
2 output is sent from the EFX OUT 1 -2/EFX 1- 2
bus, which is fed from the EFX OUT 1 -2 /EFX 1- 2
bus send on the input channels. TRS phone jack
connector pin-out - Sleeve: Ground, Tip: Hot (+),
Ring: Cold (-)
21 – USB PORT Connect standard standard USB
cable here.
22– PHONES - 1/4-inch jack (front Panel)
Connect standard stereo headphone, 60 to 600
Ohms, here.
23 - USB BUS POWER – socket
Plug any USB bus powered lamp here.
L2400 and L3200 Input and Output Connections
CD/TAPE
IN
REC
OUT
1 2
3 4
5 6
1 2
AUX SEND
EFX OUT
AUX RETURN1 2
16
17
20
19
18
USB
21
PHONES
22
23

Other manuals for Samson L2400

Related product manuals