1. Folding the base
The monitor may be reclined from -1 to 23 degrees.
2. Attaching a base
This monitor accepts a 100 mm X 100 mm VESA-compliant mounting interface pad.
A.
Monitor
B.
Mounting interface pad (Sold separately)
1. Turn off your monitor and unplug its power cord.
2. Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.
3. Turn the fixing screw handle on the stand counterclockwise to loosen it and then separate it from the
stand.
4. Align the Mounting Interface Pad with the holes in the Rear Cover Mounting Pad and secure it with
four screws that came with the arm-type base, wall mount hanger or other base.
z
Do not use screws longer than the standard dimension, as they may damage the inside of the
Monitor.
z
For wall mounts that do not comply with VESA standard screw specifications, the length of the
screws may differ depending on their specifications.
z
Do not use screws that do not comply with the VESA standard screw specifications. Do not
fasten the screws too tightly, as this may damage the product or cause the product to fall,
leading to personal injury. Samsung is not liable for these kinds of accidents.
z
Samsung is not liable for product damage or personal injury when a non-VESA or non-specified
wall mount is used or the consumer fails to follow the product installation instructions.
z
To mount the monitor on a wall, you should purchase the wall mounting kit that allows you to
mount the monitor at least 10cm away from the wall surface.
z
Contact the nearest Samsung Service Center for more information. Samsung Electronics will
not be responsible for damages caused by using a base other than those specified.
To Next Page
Loading...
