◀ ▶
English
Problem Possible Solution
I want to start
Anynet+.
●
Check if the Anynet+ device is properly connected to the TV
and check if the Anynet+ (HDMI-CEC) is set to On in the
System menu.
●
Press the TOOLS button to display the Anynet+ menu and
select a menu you want.
I want to exit
Anynet+.
●
Select View TV in the Anynet+ menu.
●
Press the SOURCE button on the TV remote control and select
a device other than an Anynet+ device.
●
Press
CH
and PRE-CH to change the TV mode. (Note
that the channel button operates only when a tuner-embedded
Anynet+ device is not connected.)
To Next Page
Loading...
