Samsung 5500 Series - Plug & Play (Initial Setup); Selecting the OSD Language; Selecting the usage mode; Selecting and memorizing channels

Plug & Play (Initial Setup)
When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings, To turn on
the
TV, press the POWERC) button,
~ Plug & Play is available only when the Source is set to TV.
~ To return to the previous step in the Plug & Play sequence, press the red button on your remote.
Press the ENTER G button,
Set up your network connection. Press the ENTER G button to start.
If you do not know
your network set up information or want to set
it up later, select Watch TV. We suggest you
skip network connection setup now and refer to "Network menu"
in the e-Manual for set
up requirements and instructions, and the Network Connection section of this manual (Page
12). You can set up the network connection later using the Network menu.
Press the
.... or ~ button. Press the'" or ,. button to select Auto or Manual, and then
press ENTER
G.
~ If you selected Auto, you'll select the time zone where you live next, and then select
whether to turn DST (Daylight Savings
Time) On or Off.
~ If you selected Manual, you'll use the number buttons or ... or ,. button to set the
date and time. Use the
.... or ~ button to move between entry fields.
POWER
~
Press the'" or ,. button to select Air or Cable, and then press ENTER GJ. A check
appears on your selection. Select Next, and then press the ENTER G button,
You can
check both
if you have both connected.
~ If you selected Cable, you'll go to the Cable System screen. Use the'" or ,. button
to select Digital or Analog, and then press ENTER G. Use the'" or ,. button to select
the correct cable signal format - STD, HRC, or IRC - and then press ENTER
[3i.
Most cable systems use STD. Select the correct cable signal format for both the
Digital and Analog systems, When done, select Search, and the press ENTER
G.
The channel search will start automatically. This can take up to 30 minutes.
For more information, refer to Channel
-> Auto Program in the e-Manual.
~ Press the ENTER G button at any time to interrupt the memorization process.
Press the
.... or ~ button, and then press the'" or ,. button to select
a language. Press ENTER
GJ when done.
Press the .... or ~ button to select, and then press the ENTER GJ
button.
• Select the
Home Use mode. Store Demo mode is for retail
environments.
Selecting and
memorizing channels
Selecting the OSD
Language
.,Setting
up the network
connection
"~ Enjoy your TV.
If You Want to Reset Plug & Play...
[S MENU!ID -> System -> Plug & Play -> ENTER G
~ To change the TV's settings from Store Demo to Home Use when not in Plug &Play, press the volume button on the
TV. When you see the volume in the OSD, press and hold MENU for 5 sec.