3 Disassembly and Reassembly
3-1
3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
MJ17CS TFT-LCD monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling these
components.
3-1 Disassembly
Cautions: 1. Disconnect the monitor from the power source before disassembly.
1. After placing monitor on the cushioned table,
remove 6 screws on the left and right of the
bottom.
2. Lift up the stand and lift up tne rear cover.
3. Remove 2 screws from the shield.
4. Disconnect function cable from the cover front and
lift up the panel. Remove 4 screws from the panel
shield. (Right / Left)
5. Lift up the panel shield and carefully remove the
silicon glue on the cables with a nipper.
Caution : Lamp wire may be easily damaged.
To Next Page
Loading...
