Disassembly and Reassembly
Samsung Electronics 3-91
No. Parts Procedure Remark
5
Ass’y cabinet
front
1) Unscrew and remove 7 screws on Assy
Cabinet Front.
(Use + Screw Driver)
6 Ass’y control
out
1) Disconnect and Separate 5 Connectors of
wire from Assy Control Out.
2) Separate Comp wire and Reactor wire from
each object.
(When you disconnect BLDC motor
connector you have to cut the power off
first and disconnect 30 seconds later And
Make sure that is impossible to connect
and disconnect BLDC motor connector
when the power is on)
3) Unscrew and remove 2 screws on of Assy
Control out.
To Next Page
Loading...
