Disassembly and Reassembly
3-22 Samsung Electronics
No Parts Procedure Remark
1 Panel
6) Disassemble the bolts that are
assembled with the indoor unit at the
4 panel corners.
7) Press the Steel Hangers at both sides
of the panel inwards, and rotate them
90 degrees to remove it from the
indoor unit’s Hock. Remove the panel
from the indoor unit.
2 Control-Box
1) Disconnect the Connector Wire that is con-
nected to the indoor unit’s PBA from the
PBA.
2) Unscrew the 2 fixed screws on both sides
of the Control Box, and disassemble the
Control Box from the indoor unit. (Use
+Screw Driver)
To Next Page
Loading...
