Disassembly and Reassembly
3-70 Samsung Electronics
No Parts Procedure Remark
4 EVAPORATOR
1) The HOLDER PIPE is fixed to body by 2
hooks as shown in the figure.
2) To detach the HOLDER PIPE from the
main frame,loosen 2 hook structhres.
When separate hooks: Use the (-) Screw
Driver. Insert the (-) Screw Driver into
the gap of the hook and lean to the
Moter side as shown in figures. (Watch
out for the damate of hooks)
3) Remove the HOLDER PIPE.
4) Unfasten a screw of the Fan Moter side.
(Use (+) Screw Driver.)
5) Unfasten 2 screws of the opposite side of
the Fan Moter.
(Use (+) Screw Driver.)
To Next Page
Loading...
