Samsung AC030KNZDCH/AA - Page 71

Installation
21!,,/+&10
NOTE
• RLA is based on AHRI 210/240 cooling standard
ʀͱʒϩͱࣄÃʒͱͱθϩʪΧࢋࡠߣߧࢋߨইAࢥߩߡই࣍U9࣎ࢥߢߪࢋߥߧইAࢥ
ߧߨই࣍Ǯ9࣎ࡡĮЇϩʒͱͱθϩʪΧࢋࡠߤߦইAࢥߪߦই࣍U9࣎ࣅ
• Ǥͱϩɇ˝ʪϩͱʪθɇʀʪϑߢߡࢋ
• đɇу*ЇɇͱиɇɵʪЭͱϩɇ˝ʪɵʪϩиʪʪΧ˵ɇϑʪϑϑߣࢋ
• Symbols
– RLA: Rated Load Ampere (A)
– MOC: Maximum Operating Current (A)
– MCA: Min&mum Circuit Ampere (A)
– MOP: Maximum Overcurrent Protective Device (A)
• Voltage range
– Units are suitable for use on electrical systems
where voltage supplied to unit terminal is not
below or above listed range limits.
• Maximum allowable voltage variation between phases
is 2%.
• Wire size & type must comply with the appl
icable local
and national code.
– Wire size: Based on the value of MCA.
– Wire type:
9Uphase: 60245 IEC57(IEC) or H05RN-F(CENELEC)
grade or more
Silence mode controller wiring diagram with
External controller
• 89@
2Pin
(RED)
4Pin
(RED)
Non-
voltage contact
External controller
• 8:<M8;8M8;>M8<:M8<@
2Pin (RED)
4Pin(RED)
Non-voltage
contact
External controller