Samsung AC030KNZDCH/AA - Page 45

Troubleshooting
Samsung Electronics 4-13
Setting an indoor unit installation option
In order to check and set the indoor unit installation option code use the wired remote controller and
follow the directions below.
1) Press the
and buttons at the same time for more than 3 seconds and then a Main menu will be
displayed.
2) Press the
/ button to select and then press button to enter a Sub-menu setting screen.
3) Press the
/ button to select and then press button to enter a Indoor unit installation option
code setting screen.
4) Press the
/ button to set the installation option code in order. Press button to go to the
next page.
SGE1 SGE2 SGE3 SGE4 SGE5 SGE6
0 2 RESERVED
Exterior
temperature
sensor
Central control RESERVED
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 RESERVED RESERVED Use of Heater RESERVED Master / Slave
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 External control
External control
output
RESERVED Buzzer RESERVED
SEG19 SEG20 SEG21 SEG22 SEG23 -
3
Individual control
of a remote
controller
Heating setting

compensation
RESERVED RESERVED -
t The rst digit represents the page number and the remaining ve digits are installation option.
t The total option codes are 24 digits. You can set six digits at a time and it is distinguished by page
number (0, 1, 2, 3).
NOTE
All manuals and user guides at all-guides.com