40
Installation Procedure
Installation
Setting the indoor unit addresses and
the installation options with wireless
remote controller
You cannot set both of the indoor unit addresses and the
installation options in a batch: set both of them respectively.
Receiver & display unit must be connected to the indoor
unit to set options with the wireless remote control.
Common steps for setting the addresses and
options
Remote controls
Setting the
option values
Entering the
mode for setting
the options
Low Temp button
High Temp button
Mode button
Low Fan button
High Fan button
NOTE
The remote control display and buttons
may vary depending on the model.
1. Enter the mode for setting the options:
a. Remove the batteries from the remote control, and
then insert them again.
b. While holding down the
(High Temp) and
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c. Make sure that you are entered to the mode for
setting the options:
2. Set the option values.
CAUTION
The total number of available options
Because SEG1, SEG7, SEG13, and SEG19
are the page options used by the
previous remote control models, the
modes to set values for these options
are skipped automatically.
Set a 2-digit value for each option pair
in the following order: SEG2 and SEG3
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 X X X X X
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1 X X X X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2 X X X X X
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3 X X X X X
On (SEG1 to SEG12) Off (SEG13 to SEG24)
DB68-11271A-02_IM_CAC Universal AHU Indoor_AA_EN_.indd 40 2022-09-15 오전 9:53:25
To Next Page
Loading...
