Samsung Electronics 4-25
No Parts Procedure Remark
6 Cushion Mid 1) As seen in the picture besides, pull out
the EPS structure located at the center of
exhaust air and supply air.
2) Pull out the EPS structure through the
inspection hole.
3) Assemble the product by adjusting it
with the direction, following the direction
carved on the surface of Cushion Mid. Put
the part written with “Down↓” downwards
and put the part with “Motor→” towards
the Motor when assembling the unit.
Make sure not to break down EPS
structure.
To Next Page
Loading...
