E-15
Selecting Heat Mode
You can select Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
Press the (On/Off) button.
Result
:
The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode you selected last.
The indoor unit beeps.
2
Press the button on the remote control until is displayed.
Result
:
The indoor unit beeps each time you press the button.
The air conditioner runs in Heat mode.
Note You can change modes at any time.
3
Press the button to adjust the temperature until the required
temperature is displayed.
You can set the temperature between 16°C and 30°C.
Result:
Each time you press the button:
- The temperature adjusts by 1°C
- The indoor unit beeps
If the room temperature reaches 5°C higher than the set
temperature, the air conditioner stops heating, but the fan
continues to operate.
If the room temperature reaches 3°C lower than the set
temperature, the air conditioner starts heating again.
4
Press the button to select the fan speed until the required setting is
displayed.
Automatic (rotated :
)
Low
Medium
High
Maximum
Result
:
Each time you press the button, the indoor unit beeps.
For the first 3~5 minutes, the fan may not operate to prevent
cool air from flowing out of the indoor unit.
This helps to warm the air in your room sufficiently.
5
To control the airflow direction, refer to page 21.
ENGLISH
To Next Page
Loading...
